78 questions. Practise this paper at your own pace.
Choose another paper or set
Loading answer access…
Question 1
Two equal resistances are connected in series across a certain supply. If the resistances are connected in parallel, the power produced will be:
Question 2
For transfer of maximum power, the relation between load resistance RL and internal resistance RI of the voltage source is:
Question 3
The breakdown voltage of an insulation depends upon... value of alternating voltage:
Question 4
At series resonance, the voltage across L or C is:
Question 5
When the total charge in the capacitor is doubled, the energy stored:
Question 6
In a balanced star connected system, line voltage are ....... ahead of their respective phase voltages:
Question 7
Magneto restriction is a phenomenon whereby the magnetism of ferromagnetic material leads to a change in:
Question 8
The no load pf of a transformer is small because:
Question 9
The main function of interpoles is to minimize between the brushes and the commutator when the dc machine is loaded:
Question 10
At lagging loads, armature reaction in an alternator is:
Question 11
If starting winding of a single-phase induction motor is left in the circuit, it will ...:
Question 12
The efficiency of three phase induction motor is approximately proportional to ...:
Question 13
Which of the following statements accurately describes the working principles of water turbines?:
Question 14
What is a key advantage of diesel power plants in certain applications?:
Question 15
Photovoltaic cell or solar cell converts...:
Question 16
Which of the following primary cells has the lowest voltage?:
Question 17
The measures to improve the transient stability of the power system during the unbalanced or unsymmetrical fault can be taken as:
Question 18
The main exciter used in DC excitation is ...:
Question 19
The static error of an instrument implies the:
Question 20
In a low power factor wattmeter, the compensating coil is connected:
Question 21
The capacitive transducers are normally used for:
Question 22
In dual slope type of Analog to digital converter, an input hold time is:
Question 23
If a power transformer has a star-connected primary and a delta-connected secondary, then the Current Transformer (CT) connections on its primary and secondary sides should be .....:
Question 24
In a closed loop control system, with positive value of feedback gain, the overall gain of the system will:
Question 25
Roots on the imaginary axis makes the system:
Question 26
Which plots in frequency domain represents the two separate plots of magnitude and phase against frequency in logarithmic value:
Question 27
In a thyristor, anode current is made up of:
Question 28
The load voltage of a chopper can be controlled by varying the:
Question 29
HVDC transmission has as compared to HVAC transmission:
Question 30
A fuse performs:
Question 31
The arc voltage in circuit breaker is:
Question 32
In static overcurrent relay, inverse time characteristics are obtained by:
Question 33
Surge absorber is used for protection against:
Question 34
Resistance earthing is employed for voltage between:
Question 35
Shunt compensation in the high voltage line is used to improve ...:
Question 36
The main drawback of overhead system over underground system is:
Question 37
Which gas has the highest breakdown strength at atmospheric pressure?:
Question 38
If the length of the cross arm is increased, the string efficiency:
Question 39
Practical loads are usually:
Question 40
The feeder is designed mainly from the point of view of:
Question 41
Synchronous condenser used for the power factor improvement is synchronous motor which operates at:
Question 42
The gas used in gas filled filament lamp is:
Question 43
Active power and apparent power are represented by:
Question 44
The typical active load is:
Question 45
In Kando System of track electrification:
Question 46
Two Part tariff is charged on the basis of:
Question 47
The chances of occurrence of corona are maximum during:
Question 48
For a transmission line which among the following relation is true?:
Question 49
If all the sequence voltages at the fault point in a power system are equal, then the fault is:
Question 50
In load flow studies of a power system, a voltage control bus is specified by:
Question 51
Which stability information is obtained from the equal area criterion?:
Question 52
VAR compensators are used to:
Question 53
Standard dimensions (mm x mm) of A3 drawing sheet in mm is:
Question 54
Which of the following methods of charging depreciation of an asset has increased amount of depreciation as the age of asset increases:
Question 55
The process of optimizing the project's limited resources without extending the project duration is known as:
Question 56
The process of composing/raising the required fund from different sources such as equity, preferred stock, bond and debenture is known as:
Question 57
In which of the following society people used to seek their existence on growing plants for their cattle and domestic animals:
Question 58
According to Nepal Engineering Council Act, 2055 (with revised, 2080), all engineering academic institutions shall be in the Council:
Question 59
Two identical cells whether joined in series or in parallel are supplied with the same current when connected to an external resistance of 1Ω. The internal resistance of each cell will be:
Question 60
The power of a 3 phase, 3-wire balanced system was measured by two wattmeter method. The reading of one of the wattmeter's was found to be double than that of the other. What is the power factor of the system?:
Question 61
The hysteresis and eddy current losses of single-phase transformer on 200V, 50Hz supply are Ph and Pe respectively. The percentage decrease in these losses when operated on 160V, 40Hz supply would respectively be:
Question 62
When load on a synchronous motor running with normal excitation is increased, armature current drawn by it increases because:
Question 63
Which winding in compound excitation is responsible for change air gap flux per pole?:
Question 64
If the DC excitation is suddenly dropped to zero, the three-phase alternator:
Question 65
In a 3-phase power measurement by two wattmeter method, the reading of one of the wattmeter was zero. The power factor of the load must be:
Question 66
For a full-scale voltage (0-5V), the resolution of 6 bit analog to digital converter (ADC) is near to:
Question 67
A step-up chopper is fed with 200V. The conduction time of the thyristor is 200μs and the required output is 600V. If the frequency of operation is kept constant and the pulse width is halved, the new output voltage will be:
Question 68
Snubber circuits are used with thyristors to:
Question 69
The neutral of 10MVA alternator is earthed through a resistance of 5Ω. The earth fault relay is set to operate at 0.75A. The current transferors have a ratio of 1000/5. What percentage of alternator winding is protected?:
Question 70
A transformer is rated at 11kV/4kV, 500kVA, 5% reactance. What is the short circuit MVA of the transformer when connected to an infinite bus?:
Question 71
The surge impedance of a 300km long overhead line is 180Ω. For a 150km length of the same line, the surge impedance in ohms would be:
Question 72
Two synchronous generators G1 and G2 rated 200 MW and 400 MW, respectively, are operated in parallel to supply a total load of 300 MW. If the governors in both machines are set to drop by 4%, what would be the individual power supplied by each generator?:
Question 73
A 230V, 10A, 1500 rpm DC separately excited motor of 0.2 ohm excited from external DC source of 50 V. Calculate the torque developed by the motor on full load:
Question 74
The candle power of a lamp placed normal to a working plane is 60 CP. Calculate the distance if the illumination is 15 lux:
Question 75
The percentage reactance of a 100kVA, 5kV, 5ohm reactance will be:
Question 76
An 800kV transmission line has a maximum power transfer capacity of 100MW. If it is operated at 400kV with the series reactance unchanged, then maximum power transfer capacity is approximately:
Question 77
Effective monthly interest rate will be ... if nominal interest rate of 10% accounted for continuous compounding:
Question 78
By considering following activities of a project, the project duration will be:
\[Table: A(4), B(5), C(3), D(7), E(5) days, predecessors: A:-, B:-, C:-, D:C, E:A,B,D]